Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • May 4, 2023 at 8:06 pm #23225

    UOMRacing
    Participant
    • University of Malta Racing

    What is diagnostic voltage in our case? Can we switch directly to 5V instead of this voltage?

    April 11, 2023 at 11:28 am #22974

    UOMRacing
    Participant
    • University of Malta Racing

    Thanks, the new dll worked.

    April 3, 2023 at 5:59 pm #22891

    UOMRacing
    Participant
    • University of Malta Racing

    We tried following the EcoFlash Manual to flash EV2106B01 using the Kvaser device. We used the CCP Protocol with the default CRO and DTO IDs and managed to open the device sucessfully. We then opened the file also sucessfully but upon pressing “Flash” we get a Warning stating “CLEAR_MEMORY Access locked.” and flashing stops. We tried several different CCP seedkeydlls found in EcoFlash’s folder but was unsuccesfull.

    We also tried using UDS but upon pressing “Flash” and asked to Key-Cycle which resulted in nothing happening(we also tried cutting it off from the power supply completely).

    How should we proceed?

    error error ccpcanoptions ccpcanoptions
  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)